316L Grade Stainless Steel Reactor Features
- Dual jacketed. Sealed outer insulation jacket provides best temperature performance inside the chamber
- All wetted parts on main vessel and lid built with pharmaceutical-grade 316L SST
- Shell and tube heat exchanger with 70 tubes for the best condensing results
- ElectroPolished internal chamber
- Detachable condenser and collection tanks
- Dual collection tanks with big sight glass allows you to drain without breaking vacuum
- High drain port clearance for easy draining or added filtration
- Large ports (top 12" bottom 6") allows easy chamber cleaning
- Top placed vacuum port on condenser provides better flow and condensing results
- No messy cable, with space-saving integrated stirring motor controller
- Heavy-duty stainless-steel frame with swivel casters
- Built-in flashlight gives you a clear view inside the chamber
- Positive/negative pressure gauge
- Matte finish stainless steel
- Customizable lid for various application
- Tons of tri clamps adapters available, e.g. tri-clamp to hose barb/KF25/NPT
- Choice of bolted or pin clamp for various pressure applications
- Flexible bellow condenser connection reduces shipping damage
- Electric motor and controller model is ETL certified to UL and CSA standards
- A peer-reviewed model (pneumatic motor and controller) is approved to be used with Acetone, Ethanol, Heptane, Hexane, Isopropyl Alcohol, Methanol, and Pentane.
CAUTION!
- Never fill circulated heaters or chillers with water, always use Ai or the manufacturer's recommended thermal fluid
- Always leave ample fluid space in the heater reservoir to allow fluid heat expansion
- Always keep system vacuum passage or drain valve open when heating up circulation jackets
- Always make sure your vacuum pumps and diffusion pump fluid is clean and within limits
SPECIFICATIONS
SR200 Electric stirring motor
220V, 50/60Hz, 1~Phase, 200 watts, 1/4 HP
Rotation: 450 rpm max. (±8%)
Starting torque: 3.0 N.m
Rated torque: 1.54 N.m
Built-in gearbox ratio: 3:1 to 180:1
Controller: Delta, UL listed
SR200 Pneumatic stirring motor
- Power: 1/4 HP - Rotation: 450 rpm max. (±8%) - Compressed air pressure range: 30 to 80 psi (0.2 to 0.55 MPa) - Working temperature: -10C to +70C - For constant use: set rpm to 80% of maximum rpm - Motor lubricant
- Daphne Eponex EP-No. 1
- Check/replenish/replace every 500 hours
- Air lubricant
- Type: JIS K2213-1 (ISOVG32)
- Recommended products: Shell Vitrea Oil 32, JOMO Turbine 32, COSMO Turbine 32
- Speed: 2-3 drops per minute
- For safety purpose, detach compressed air supply when not in use, left un-attended or at night - Do not run motor un-loaded - Set Air Adjuster to minimum at initial run, make sure motor is working properly, before increasing CFM - Before inspecting unit, stop the motor and detach air supply. Do NOT inspect unit when motor is in action. - Make sure exhaust port/hole is clear from any debris or blockage - Check every 2-3 days: Air Lubricant, Air Filter water drain
|
SR200 Port configuration
Lid: 6" triclamp
Center motor port: 3" triclamp
Drain port: 6" triclamp
Drain port on/off valve: 2" triclamp
Vacuum port: 1.5" triclamp
Condenser recirculating fluid port: 1/2" female NPT
Vessel jacket recirculating fluid port: 1" female NPT
50L/100L collection tanks